im preparing a project for an Arquitect studio with realflow, they want me to simulate the collapse of an industrial crane when lifting a huge charge, they want the simualtion being as closer to real crane behaviour as possible, they gave me a table of masses for the crane and the charge. Im having problems with this, it is supposed the volume for a cube is computed as,
Volume = side*side*side,
then the mass would be volume*density, supposing a default density of 1000 gr/m3 the final mass of a cube of side 1 should be 1000 gr, howver realflow assign a mass of 500 units to the unit cube, may any body tell me why? is this a bug?
Discussions about rigidbody simulation in Realflow 4
3 posts • Page 1 of 1
Ok man Kgr/m3, my question is why the default mass of an unit cube in realflow is 500.0 when it should be 1000.0, I know I can set my own mass value but as Im trying to make my sim as close to real measures as possible , I need to know why realflow assign the default mas 500.0 to adjust my own data to the realflow units, if as I gess this is a bug and the correct mass would be 1000.0 It is no need to fit my data and my work woulb be easier, may anybody clarify this issue?
Who is online
Users browsing this forum: No registered users and 3 guests